(BPT) – Contemplate this — for the similar amount of money of time and power required to strip, sand and stain a wooden deck, you could replace these boards with composite decking and never ever once again have to fret about repairs. Created for highest toughness and minimum maintenance, wooden-choice decking, like Trex, is resistant to fading, staining, scratching and mould, and just an occasional soap-and-water cleansing is all it usually takes to keep a “like-new” overall look for decades.

Resurfacing a deck is a doable Diy project that can be done in a weekend or two with just a very little know-how and the aid of a handful of friends. Basically observe these measures from the experts at Trex Academy to give your aged wood deck a makeover with higher-efficiency, headache-free of charge composite decking.

1. Take away aged deck boards

Start by eliminating any railing and prying up the existing deck boards. Depart the substructure and framing in position.

2. Clear the body

Guarantee that all fasteners and hardware have been taken out from the top rated of the deck body. If nails cannot be taken out, bend the strategies about so they lie flat on the wooden for protection. Take out any debris from the bays between joists to allow for air to flow beneath the body.

3. Inspect the substructure

Check out the beams and joists of the framing to make sure these foundational factors are totally free of rot and decay. Use a flathead screwdriver to probe for comfortable places. Restore or change any decayed or rotting framing ahead of continuing.

4. Shield joists and beams

For added protection and to prolong the everyday living of your deck, apply protective flashing tape, such as Trex Secure to the joists and beams of the substructure. This straightforward-to-use, self-adhesive tape will help to safeguard wood and steel fasteners from moisture that can guide to rot, rust and decay.

5. Install new deck boards

Start laying out the new composite deck boards commencing with the board farthest absent from the property. Be absolutely sure to closely observe the manufacturer’s guidance for spacing to ensure correct ventilation.

6. Shuffle the deck

Composite decking is created with random variation in hue from board to board. For the most purely natural-looking final results, shuffle — or blend — the boards to generate your wanted glance. This can be performed by laying out various classes of boards and organizing them to your liking before putting in.

7. Body and complete

After the deck boards are in area, use a round saw to trim any overhang for clean up, completed edges. Then re-attach railing parts or increase new railing shelling out near awareness to the manufacturer’s set up information and local constructing codes.

8. Decorate and get pleasure from!

Increase furnishings and decorative things to finish items off. Then, phase again, admire your work and appreciate your new, headache-cost-free outside place.

For extra skilled assistance and means, including a step-by-move deck resurfacing online video, visit the Trex Academy area of Trex.com.

Facebooktwitterredditpinterestmail